Troubleshooting; Possible Cause; Grinding Plate - Scheppach DS920X Originalbetriebsanleitung

13. Troubleshooting

Supposed malfunctions, errors or damages are often caused by events which can be remedied by the operator.
Therefore check the power tool on the basis of the following table before you contact a specialist. Many malfunc-
tions may thus be remedied.
Problem

Possible cause

Power tool does not Power supply interrupted
start
Power cord or plug defective
Other electrical defect of the power tool
Power tool does not Extension cord too long and/or cross-
operate with full power section too small
Power supply (e.g. generator) voltage
too low
Poor operation results Power tool worn out
Grinding plate worn out
Considerable dust Brush edge worn out
formation
Dust extraction not connected / switched
on
30 | GB www.scheppach.com
Approach
Check power supply by connecting
another power tool
Have an electrician check the tool
Have an electrician check the tool
Use extension cord with permissible
length and/or adequate cross-section
Connect power tool to an appropriate
power supply
Replace insertion tool
Have grinding plate replaced
Have brush edge replaced
Connect / switch dust extraction
Explication des symboles utilisés sur le dispositif
m
Attention! Le non-respect éventuel danger de mort, risque de blessures ou
de dommages à l'outil!
AVERTISSEMENT - pour réduire le risque de blessure, lisez le mode
d'emploi!
Portez des lunettes de protection!
Portez une protection auditive!
Portez un masque anti-poussière!
Catégorie de protection II
www.scheppach.com FR | 31