Troubleshooting; Possible Cause - Scheppach 5903802901 Original Bedienungsanleitung

12. Troubleshooting

Fault
Power tool does not start
Power tool does not operate
with full power
Poor operation results
Considerable dust formation Brush edge worn out
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

Possible cause

Power supply interrupted
Power cord or plug defective
Other electric malfunction of the power tool Have an electrician check the tool
Extension cord too long and/or cross-
section too small
Power supply (e. g. generator) voltage too
low
Accessory worn out
Sanding plate worn out
Dust extraction not connected/switched on Connect/switch on dust extraction
Remedy
Check power supply by connecting another
power tool
Have an electrician check the tool
Use extension cord with permissible length
and/or adequate cross-section
Connect power tool to an appropriate
power supply
Have accessory replaced
Have sanding plate replaced
Have brush edge replaced
GB | 27