Starting Operation Of Unit With Coating Material; Socket On Unit; Spraying Technique; Handling The High-Pressure Hose - WAGNER Super Finish 27 Betriebsanleitung

Starting operation/ Spraying technique

2
4.7
STARTING OPERATION OF UNIT WITH COATING
MATERIAL
1. Super Finish 27
Before mounting suction system or upper hopper,
check inlet valve for functionality. Press inlet valve
with a soft implement (e.g. a pencil); it must allow
Attention
movement.
2. Unit with suction system
Submerge suction pipe into a container filled with coating
material.
3. Unit with upper hopper
Fill coating material into the upper hopper.
4. Super Finish 31
Press inlet valve trigger (fig 11, item 1) several times to
release possibly clogged inlet valve.
5. Set multifunction switch (2) to
unit will start. Turn pressure regulating knob (3) to the right
until stop.
6. When the sound of the valves can be heard clearly, the unit
is ventilated.
7. Set multifunction switch (2) to
of spray gun, then set the desired operating pressure by
means of the pressure regulating knob (3).
8. The unit is ready for spraying.

1
2
3
4.8

SOCKET ON UNIT

It is possible, for example, to connect an agitator, a working
lamp etc with a maximum of 1000 Watt.
34
GB
1
(ON - circulation); the
(spray). Pull trigger guard
Completely unroll a connected cabledrum.
Attention
So that in switching on the unit the mains
fuse protection of 16 A does not react: Always
switch on the Super Finish 27 or31 unit first
and then the connected unit.
Attention
5.

SPRAYING TECHNIQUE

Guide the spray gun evenly during the spraying process. If
this is not observe, an irregular spraying appearance will be
the result. Spray with the arm and not with the wrist. Maintain
a parallel distance of approx. 30 cm, between the spray gun
and object of spraying. The lateral limitation of the spray jet
should not to be too distinct. The edge of the spraying should
be gradual to facilitate overlapping of the next coat. Always
guide the spray gun parallel to and at an angle of 90°to the
spraying area; in this way the least paint cloud arises.
If very distinct edge zones appear and streaks
i
in the spray jet – increase operating pressure or
dilute coating material.
6.
HANDLING THE HIGH-PRESSURE
HOSE
The unit is equipped with a high-pressure hose specially suit-
ed for diaphragm pumps.
Danger of injury through leaking high-pres-
sure hose. Replace any damaged high-pressure
hose immediately.
Never repair defective high-pressure hoses
Attention
yourself!
The high-pressure hose is to be handled with care. Avoid sharp
bends and folds: the smallest bending radius is about 20 cm.
Do not drive over the high-pressure hose. Protect against
sharp objects and edges.
Never pull on the high-pressure hose to move the device.
Make sure that the high-pressure hose cannot twist. This can
be avoided by using a Wagner spray gun with a swivel joint
and a hose system.
When using the high-pressure hose while work-
i
ing on scaffolding, it is best to always guide the
hose along the outside of the scaffolding.
The risk of damage rises with the age of the
i
high-pressure hose.
Wagner recommends replacing high-pressure
hoses after 6 years.
For reasons of function, safety and durability,
i
only use original WAGNER high-pressure hoses.
Super Finish 27 • 31