Coating Materials Not Suitable For Use; Preparation Of The Workplace (For Interior Wall Paint); Preparation Of The Coating Material - WAGNER W 510 Originalbetriebsanleitung

GB

7. Coating Materials Not Suitable for Use

Materials that contain highly abrasive components, plaster, facade paint, caustic solutions
and acidic coating substances. Flammable materials.

8. Preparation of the workplace (for interior wall paint)

Sockets and plugs must be masked. Risk of an electric shock as a
consequence of sprayed material entering the socket!
Mask all the areas and objects that are not to be spray painted, or
remove them from the work area. No liability is assumed for damage
due to overspray. Silicate paint corrodes glass and ceramic surfaces
upon contact! All such surfaces must therefore be completely covered.
Pay attention to the quality of the adhesive tape used.
i
Do not use excessively strong adhesive tape on wallpaper and painted
surfaces, in order to avoid damaging these surfaces when removing the
tape. Remove adhesive tape slowly and evenly; do not use jerky movements.
Do not leave adhesive tape on surfaces any longer than necessary, in order
to minimise the possibility of residues when removing.
Also observe the adhesive tape manufacturer's instructions.

9. Preparation of the Coating Material

The enclosed spray attachment can be used to spray interior wall paints, varnishes and
glazes that are undiluted or slightly diluted. Detailed information is available in the
technical data sheet of the manufacturer ( Internet Download).
1. Stir the material thoroughly and dilute it in the container as per the recommended
dilution.
Spray attachment Sprayed material
24
Thinning recommendation
Glazes
Wood preservatives, mordants, oils,
disinfection agents, plant protective agents
Paints containing solvents and water-
soluble paints, primers, vehicle coating
paints, thick-film glazes
Interior wall paint (dispersions and latex
paint)
W 510
undiluted
undiluted
dilute by 0-10 %
dilute by 0-10 %