Replacing Components - Siemens SINAMICS DCM Betriebsanleitung

9.3 Maintenance
Servicing involves activities and procedures for maintaining and restoring the specified
condition of the device.
Required tools
The following tools are required for replacing components:
● Wrench or socket wrench, width across the flats 10, 13, 16/17 and 18/19
● Hexagon-socket wrench (size 8)
● Torque wrench, 5 Nm to 50 Nm
● Screwdriver size 1 / 2
● Torx T20 and T30 screwdrivers
Tightening torques for current-carrying parts
When securing connections for current-carrying parts (motor connections, busbars), you
must observe the following tightening torques.
Table 9- 1
Screw
M6
M8
M10
M12
9.4

Replacing components

The following must be taken into account when the devices are transported:
• The devices are heavy or generally top heavy. The center of gravity is marked on the
• Due to their weight, the devices must be handled with care by trained personnel.
• Serious injury or even death and substantial material damage can occur if the devices
SINAMICS DCM Cabinet
Operating Instructions, 04/2015, A5E36161239/RS-AA/001
Tightening torques for connecting current-carrying parts
WARNING
devices.
are not lifted or transported properly.
Maintenance and servicing
Torque
6 Nm
13 Nm
25 Nm
50 Nm
9.3 Maintenance
119