Disassembling The Crane Transport Assembly - Siemens SINAMICS DCM Betriebsanleitung

Mechanical installation
3.3 Mounting
Center of gravity of cabinet
The diagram below shows the center of gravity of the cabinet (for all sizes), which must
always be taken into account when lifting and installing the cabinet.
Figure 3-8
Note
A sticker with the precise position of the center of gravity of the cabinet is attached to each
cabinet and/or each transport unit.
3.3.3.2

Disassembling the crane transport assembly

With option M90, the cabinets are supplied with top mounted crane transport aids:
● Transport eyebolts at a width of the cabinet or transport unit from ≤1600 mm
The transport eyebolts can be unscrewed and removed.
● Mounting rails at >1600 mm
The mounting rails can be dismantled by unscrewing the fixing screws.
Figure 3-9
46
Center of gravity of the cabinet
WARNING
The mounting rails are heavy and must be removed very carefully.
Screws can fall into the cabinet when it is disassembled and can cause serious damage
when the equipment is operated.
Option M90 fitted with mounting rails
Operating Instructions, 04/2015, A5E36161239/RS-AA/001
SINAMICS DCM Cabinet