Using Gps For The First Time, And Sensors - JVC KD-NX10 Bedienungsanleitung

Installation/Connection Manual

Using GPS for the first time, and sensors

• Switch on the vehicle ignition to start using GPS for the first time
and for the sensor test. Switching on the unit. Enter the code (see
the operation guide for a detailed description).
• Press multifunction button
at the same time.
• This calls up the menu for the initial GPS start-up and for the sen-
sor test.
• Move the vehicle several metres forwards or backwards for the
speed signal function test.
The number under
The number under
pressing the accelerator when the vehicle is parked.
• Engage the reverse gear for the reverse signal function test.
The arrows under
gaging the reverse gear.
196
and multifunction button
must change (even at a low speed).
Speed
should not increase when idling or
Speed
Direction must change direction on en-