The Angle Guide; Grinding Tool Blades - Westfalia 32 59 69 Bedienungsanleitung

The Angle Guide

An angle guide is included with the machine. The gauge has slots with which the
cutting angle of a blade can be determined and it can be used on the stone to set
the grinding angle.
The guide can be used for grinding angles of 20, 25, 30, and 65 degrees.
1. Clamp the tool into the support plate and place it on the support as shown to
set the grinding angle. The tool support plate should be as close to the stone
as possible for maximum control over the grinding process.
2. Place the angle guide on the stone and on the tool as shown below. Then
adjust the height of the tool support until the tool tip touches the full length of
the angled surface on the angle guide and both ends of the angle guide touch
the stone. The correct placement is shown in the figure.
3. Once the desired angle is set, remove the angle guide and tightly clamp the
tool down in the tool support plate.
Angle Guide
Front End
of Guide

Grinding Tool Blades

1. After the tool support and the angle are set up as described above, all you
need to do is lifting the tip of the tool off the stone and start the machine.
Operation
Tool-
Tip
Tool
Support
Plate
14
Tool
Support