The Angle Guide - Westfalia RKS200B Bedienungsanleitung

The Angle Guide

An angle guide is included with the machine. The gauge has slots with which the
cutting angle of a blade can be determined and it can be used on the stone as
shown below to set the grinding angle.
The guide can be used for grinding angles of 20, 25, 30, and 65 degrees.
To set the grinding angle, clamp the tool into the support plate and place it on the
support as shown. The tool support plate should be as close to the stone as
possible for maximum control over the grinding process. Place the angle guide on
the stone and on the tool as shown below. Then adjust the height of the tool
support until the tool tip touches the full length of the angled surface on the angle
guide and both ends of the angle guide touch the stone. The correct placement is
shown below.
Once the desired angle is set, remove the angle guide and tightly clamp the tool
down in the tool support plate.
Angle Guide
Front End
of Guide
Operation
Tool-
Tip
Tool
Support
Plate
11
Tool
Support