Preparation Connections - Sony UPA-D3 Gebrauchsanweisung

Preparation
Connections
The UPA-D3 is connected to the modalities through an ethernet line and to the
printers through the SCSI interface.
Before connecting the computer, see "Important safeguards/notices for use in the
medical environment" on page 2.
Notes
• Turn off power to each device before attempting to make any connections.
• Connect the AC power cord last.
• Grasp the plug at the end of the AC power cable, and firmly insert it into the
socket.
• For details of how to connect to the ethernet line and printers, refer to the
instruction manuals supplied with peripheral equipment.
• Firmly insert the SCSI cable connector into the connector on the unit. It is
properly connected when it clicks into places.
• Keep the length of the SCSI cabling as short as possible. If operation of the SCSI
interface is unstable, insert a SCSI booster between the unit and printers.
• Use the SCSI addresses 1 to 6 (ID number) for the printers connected to the unit.
Do not use 0 or 7.
• Do not attempt to use NETWORK 10BASE-T and NETWORK 10BASE-5 at the
same time. Connecting to both connectors at the same time may damage the
internal circuits.
• Connect printers and other peripheral equipment to the same AC power line as
the UPA-D3. Connecting them to different AC power lines may cause unstable
operation because of differences in potential between power lines.
For details on how to set SCSI addresses, termination, and other settings, refer to
the instruction manuals supplied with the printer.
For customers in Netherlands
Voor de klanten in Nederland
• Dit apparaat bevat een MnO
• Raadpleeg uw leverancier over de verwijdering
• Gooi de batterij niet weg, maar lever hem in als
• Bij dit produkt zijin batterijen geleverd. Wanneer
memory back-up.
van de batterij op het moment dat u het apparaat bij
einde levensduur afdankt.
KCA.
deze leeg zijn, moet u ze niet weggooien maar
inleveren als KCA.
Li batterij voor
2-
9
Preparation