Precautions; Safety; Installation; Cleaning - Sony UPA-D3 Gebrauchsanweisung

Precautions

Safety

Installation

Condensation
Location

Cleaning

8
Introduction
• The UPA-D3 models for use in the USA and Canada require a 100 VAC to 120
VAC power supply. The European model requires a 220 to 240 V AC power
supply.
• Be careful not to damage the power cable by placing or dropping heavy objects
on it. It is dangerous to use the unit with a damaged power cable.
• If the unit will not be used for a long time, disconnect the power cable.
• When disconnecting the power cable, grasp the plug, not the cable.
• Do not disassemble the unit
• Do not remove the cover. There is a danger of electric shock from the internal
parts.
• Do not spill water or other liquids on the unit, or allow combustible or metallic
materials to enter the cabinet. Foreign objects can cause failure, fire, or electrical
shock.
• Do not obstruct cooling vents with other units, cloth or other obstructions. Doing
so may cause overheating.
• If the unit malfunctions or if a foreign objects falls into the cabinet, disconnect
power immediately and call your Sony dealer.
• Avoid placing the unit in a location subject to
- mechanical vibration
- high humidity
- excessive dust
- direct sunlight
- extremely high or low temperature
• Do not place a heavy object such as a monitor on the unit.
• Do not use other electronic equipment near the unit. The digital image processor
will not work properly when placed in a strong electromagnetic field.
Do not expose the digital image processor to wide and sudden changes in
temperature. If it is moved from a cold room to a warm room, or kept in a room
with a heater that produces a large amount of moisture, condensation may form
inside the unit. This may damage the unit. If condensation does form, turn off
power to the unit and leave it off for about one hour.
To prevent internal buildup of heat, leave room around the digital image processor
for air to circulate through its cooling vents.
Clean the cabinet, panel and controls with a soft dry cloth, or a soft cloth lightly
moistened with a mild detergent solution. Do not use any type of solvent, such as
alcohol or benzine, which may damage the finish.