Rear - Sony UPA-D3 Gebrauchsanweisung

Rear

AC IN
~ AC IN connector
1
Connects the unit to a wall outlet using the
supplied power cord.
Network port
2
Connects the unit to the network.
There are the following two connectors as the
network port.
Connect either of the two according to the
network.
• NETWORK 10BASE-T
• NETWORK 10BASE-5
Note
Do not attempt to connect to both the10BASE-
T and 10BASE-5 connectors at the same time.
Doing so may damage internal circuits.
SERIAL connector (D-SUB 25pin)
3
Not used in normal operation.
Connecting a computer to this port allows the
unit to be adjusted and monitored.
For detailed information, contact your nearest
Sony dealer.
SERIAL SCSI
NETWORK 10BASE-5
NETWORK
10BASE-5
SCSI connector (Half pitch 50-pin)
4
Connects the unit to the printer. Up to six
printers can be connected.
Equipotential ground terminal 1
5
(European model only)
Used to connect to the equipotential plug to
bring the various parts of a system to the same
potential.
Refer to "Important safeguards/notices for use
in the medical environment" on page 2.
7
Introduction