Location And Function Of Parts; Front - Sony UPA-D3 Gebrauchsanweisung

Location and Function of Parts

For details, refer to the pages indicated in parentheses.

Front

POWER
POWER RUN
POWERu switch
1
Press to switch the unit on or off. The
POWER lamp lights green when the power is
on.
POWER lamp
2
Lights green when the power is on.
Note
Do not remove the AC power cord while the
POWER lamp is lit. Doing so may damage the
built-in hard disk.
Reset hole
3
Not used in normal operation. Used to turn off
the power without using the POWER switch.
Insert a paper clip, the tip of a mechanical
pencil or some other pointed object into the
reset hole and push it.
RUN indicator
4
Lights green when the unit is ready to receive
image data from a modality.
6
Introduction
DISK NETWORK QUEUE
DISK indicator
5
Lights green when image data is being written
or loaded to or from the hard disk. Also it
lights green when a command is being sent to
the printer.
NETWORK indicator
6
Lights green when image data and commands
are transferred between the modality and the
unit.
QUEUE indicator
7
Lights orange when image data is temporarily
stored in memory of the unit and the printer is
printing the image data sent from the unit.