Sony LH51 Bedienungsanleitung Seite 62

Setting the tool coordinate for tool No. 2
TOOL
X axis machining datum point
0
Tool No.2
X H
Workpiece
+
X
1
Z-axis machining datum point
Tool No.2
Z 0
54
Operating Procedure
Press the keys and call the cutting tool
2
corresponding to tool No.2.
Using the cutting tool No.2, machine the
outside of the workpiece in the direction of the
X-axis.
Hold the X-axis display.
Measure the diameter of the machined
workpiece with a micrometer.
mm
Enter the diameter of the workpiece on the X-
axis to set the machining datum point.
0 S
Note
Be sure to input the value as the diameter.
To make a datum point for the Z-axis
direction, align the cutting edge of the No.2
cutting tool with the surface of the Z-axis
machining datum point.
To set the Z-axis machining datum point,
press the Axis selector key for the Z-axis, the
S
key and the datum point setting key.
0
Set tool numbers 3 through 9 in the same manner.
Note
Even when the tool No. for a cutting tool is changed, it is not necessary to reset the machining
datum points for the X and Z axes provided that the shape and datum point of the workpiece
remain the same.
Display
Tool No. 2 display
Present value display
ABS lights up./Display held.
ABS lights up./Display held.
ABS lights up.
Present value display
(The present value changes so that the held value
reads "10.0000".)
Present value display
ABS lights up.
Z