Mid-Point Calculation - Sony LH51 Bedienungsanleitung

5-6-4. Mid-point calculation

X
C L
To make the center position the datum point, operate as follows
X
0
S
30
When the INC mode display is selected, the distance from the center value is displayed by halving
the displayed value.
Note
In the example, the resolution is set to 0.0005 mm.
Operating procedure
If the ABS mode display is selected, change it
to the INC mode before operating.
The present value is displayed.
Select the X-axis.
Press the 1/2 key.
The INC indicator lights.
Move the machining table until the display
reads "0".
This position is the center.
Select the X-axis.
"0" input can be omitted.
Press the datum point setting key.
The ABS indicator lights.
Note
If the operation above is performed, the preset
datum point is canceled.
Display
ABS, INC lights up
Counting
ABS, INC lights up
ABS, INC lights up