Sony LH51 Bedienungsanleitung Seite 40

F
X 1 0
Y 1 0
SET
L
[When the bolt hole circle function is selected]
X
For a diameter of 10 mm
1 0
P
For a division number of 100
1 0 0
P
For a starting angle of 45
4 5
P
32
Operating Procedure
Press the key to set the BH/ARC mode.
F
Enter the center point.
For X=100 mm
0 P
For Y=100 mm
0 P
Note
Align the scale position with the center of the
circle before starting.
Press the Function setting key.
The BH/ARC data input mode is entered.
Select diameter (
Press the number keys.
Press the Preset key.
Press the number keys.
Press the Preset key.
(Maximum 360 divisions, corresponding to
360˚.)
Note
Angle calculations are performed in 0.01° units.
0.001 ° units are calculated by linear
interpolation using the 0.01° unit values.
Therefore, a hole position error occurs if division
results in a fraction less than 0.01°.
°
Press the number keys.
Press the Preset key.
(0° to 359.999°, in 0.001° units)
).
Display
BH/ARC
Lights up
BH/ARC
Lights up
BH/ARC
Lights up
BH/ARC
Lights up
BH/ARC
Lights up