Using The Emergency Light; Changing The Lens And Replacing The Illuminant; Cleaning, Maintenance And Technical Data - Westfalia 64 77 19 Bedienungsanleitung

Using the Emergency Light

With the switch (4) the emergency light can be turned on ("LIGHT") or set to
flashing mode ("FLASH"). In the "OFF" position the light is turned off.

Changing the Lens and Replacing the Illuminant

To change the lens (3), unscrew the outer ring by turning counter
clockwise. Now you can replace the lens.
With ring and lens removed from the unit, you have now access to the
illuminant. Turn the bulb to line up the triangular marks on the bulb and the
reflector line up. Now you can pull the old bulb from the unit and replace it
with a fresh one of the same type and dimensions. After that reattach lens
and ring and tighten the ring by turning clockwise.
Cleaning and Maintenance
Before undertaking any cleaning or maintenance (e.G. changing the
illuminant) on the compressor, please pull the power plug and allow the
unit to fully cool down.
Use only a damp cloth to clean the unit. Do not use aggressive chemicals
or abrasives.
Technical Data
Power Supply ...........................................................12 V DC
Nominal Current Consumption .................................max. 10 A
Max. Pressure ..........................................................17 Bar / 250 PSI
Weight ......................................................................approx. 1450 g
Dimensions...............................................................approx. 195x245x110 mm
Start-Up and Operation
8