AEG BO4GESKM Benutzerinformation Seite 26

Top lamp
1. Turn the glass cover to remove it.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
You cannot activate or operate the
oven.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The food sensor does not operate.
The display shows F111.
The display shows an error code
that is not in this table.
26 ENGLISH
2. Remove the metal ring and clean the
3. Replace the lamp with a halogen, 230 V,
4. Attach the metal ring to the glass cover
Possible cause
The oven is not connected to an
electrical supply or it is connected
incorrectly.
The oven is turned off.
The clock is not set.
The necessary settings are not set.
The automatic switch-off is on.
The Child Lock is on.
The fuse is blown.
The lamp is defective.
The plug of the food sensor is not
correctly installed into the socket.
The plug of the food sensor is not
correctly installed into the socket.
There is an electrical fault.
glass cover.
40 W, 300 °C heat-resistant lamp
and install it.
Remedy
Check if the oven is correctly con‐
nected to the electrical supply (refer
to the connection diagram if availa‐
ble).
Turn on the oven.
Set the clock.
Make sure that the settings are cor‐
rect.
Refer to "Automatic switch-off".
Refer to "Using the Child Lock".
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Replace the lamp.
Put the plug of the food sensor as
far as possible into the socket.
Put the plug of the food sensor as
far as possible into the socket.
• Turn off the oven with the house
fuse or the safety switch in the
fuse box and turn it on again.
• If the display shows the error
code again, contact the Custom‐
er Care Department.