Herunterladen Diese Seite drucken

AEG BO4GESKM Benutzerinformation Seite 25

Vorschau ausblenden Andere Handbücher für BO4GESKM:

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

These reminders activate each time you turn
off the appliance.
12.7 Rinsing
Use it to clean the steam system after
frequent use of the steam functions.
1. Turn off the appliance and wait until it is
cold.
2. Remove all accessories.
3. Place the deep pan on the first shelf
position.
4. Fill the water drawer with water to the
maximum level until the signal sounds or
the display shows the message.
5. Select: Menu / Cleaning / Rinsing.
Duration: around 30 min
6. Turn on the function and follow the
instruction on the display.
7. When the function ends, remove the deep
pan.
When this function works, the lamp is off.
12.8 Tank Emptying
Use it after cooking with steam heating
function to remove the residual water from
the water drawer.
1. Turn off the appliance and wait until it is
cold.
2. Remove all accessories.
3. Place the deep pan on the first shelf
position.
4. Select: Menu / Cleaning / Tank Emptying.
Duration: 6 min
5. Turn on the function and follow the
instruction on the display.
6. When the function ends, remove the deep
pan.
When this function works, the lamp is off.
12.9
The number of glass panels is different for
different models.
CAUTION!
Carefully handle the glass, especially
around the edges of the front panel. The
glass can break.
1. Hold the door trim
the door at the two sides and push
inwards to release the clip seal.
2
B
2. Pull the door trim to the front to remove it.
3. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide.
4. Clean the glass panel with water and
soap. Dry the glass panel carefully. Do
not clean the glass panels in the
dishwasher.
After cleaning, do the above steps in the
opposite sequence. Install the smaller panel
first, then the larger and the door.
Make sure that the glass panels are inserted
in the correct position otherwise the surface
of the door may overheat.
12.10 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the appliance and wait until it is
cold.
2. Disconnect the appliance from the mains.
3. Place the cloth on the oven floor.
on the top edge of
1
ENGLISH
25

Werbung

loading