Herunterladen Diese Seite drucken

Philips RC670 Bedienungsanleitung Seite 4

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

MOUNTING
METAL SLEEVE (fig.5)
* Install the metal sleeve (dimension 182x53 mm) in the dashboard. For optimal performance
_ >)
10°
of the CD player*, the metal sleeve should be positioned horizontally (between -10° and
+80°).
* Fix metal sleeve into place by pressing the metal tags outwards using a screwdriver.
MOUNTING RADIO
This radio can be properly installed either from conventional Front Mounting or Rear Mounting.
FRONT MOUNTING
* Slide the radio into the metal sleeve until the springs at either side of the radio snap into the openings
of the sleeve (fig.6).
* Finally reconnect the negative car battery terminal (fig.7).
REMOVING
RADIO (using the two U- brackets supplied)
« Remove the front, see 'SECURITY', 'DETACHABLE FRONT'.
* Remove the trimplate around the front panel.
* Insert both U-brackets into the holes on the front of the set until they lock. Pull out the radio (Fig.8).
REAR MOUNTING (fig.9)
+ Remove the trimplate around the front panel and the side springs.
* Select a position where the screw holes of the mounting bracket and the screw holes of the radio
become aligned and tighten the screws at 2 places on each side.
* Only use M5 screws that are not longer than 6mm.
REPLACING FUSE (Fig. 2)
* Replace with a 10A blade-type fuse. The new fuse must be of exactly this value and type otherwise
the set will not be adequately protected. Ignoring this procedure may lead to damage to the set, which
will invalidate the guarantee.
INTERFERENCE SUPPRESSION
« Most modern cars have sufficient interference suppression. If you experience interference generated
by the car, consult your garage.
LEGEND
ENVIRONMENT
This booklet is printed on low-chlorine
—S
Briefly press the key.
EO recyclable paper that can be used for
recycling.
CF
Press and hold the key.
CHECK BEFORE REQUESTING SERVICE
There may be times when you suspect that your
a)
F
car radio is not functioning as you expected it to.
e) —-
Press the key until you hear a
Before calling for service, please read the
confirmation beep.
operating / installation instructions and check for
useful tips
under each section. You may find that
are
Turn the rotary knob.
an apparent malfunction can easily be rectified.
ei
If you still have to send your set for service, always
Oa
Useful tips
send the complete set (with detachable front). Do
not try to open the set to service it yourself.
* Depending on version

Werbung

loading