Philips RC670 Bedienungsanleitung Seite 10

RADIO
WAVEBAND
+ Select the desired waveband :
BAND
SCAN
The display shows :
FM1 or FM2 or FM3, MW1, or MW2, or LW
(when Choice is 'EUROPE' under 'RADIO'
option; see INITIAL SETTINGS). -
FM1 or FM2 or FM3, AM1, or AM2
(when Choice is 'LATAM' or 'AMERICA' or 'ASIA'
under 'RADIO' option; see INITIAL SETTINGS).
2@ Useful tips
You can suppress MW or LW bands if not in used.
* See INITIAL SETTINGS; select Option 'MW'
or 'LW' and set Choice to 'OFF'.
SEARCH TUNING
Use search tuning to automatically search for a
station.
* Tune to a station of a lower ( WM) or higher
frequency (FY):
sa
=>
— You will receive a station after a short time. To
search for another station, press the key again.
2 Useful tips
Cannot tune to desired station?
Check that the aerial is fully extended and
properly connected.
* Check that the negative terminal (brown lead)
is connected to earth (car chassis).
Desired station is too weak, try Manual Tuning.
See INITIAL SETTINGS; check option 'RADIO'.
Set is in TA mode : only stations with Traffic
Announcements can be tuned in. If necessary,
switch off the TA mode.
Search tuning stops too frequently (FM bands
only).
* You can adjust its sensitivity, see INITIAL
SETTINGS; option 'SRCH'.
* Depending on version
10
Bos Useful tips
Poor tuner reception?
In some cars (e.g. VW and Seat) there is an
active aerial on the roof that needs 12 Volt
supply. Please ask your dealer to check
whether 12 volt is supplied to the antenna.
MANUAL TUNING (if you know the frequency
of the required station)
* To switch to manual tuning :
=}
2
¢ Tune to the desired frequency :
After about 1 minute with a beep the radio
automatically switches back to search tuning
MANUALLY STORING STATIONS
PRESET
Six stations per waveband can be stored and
recalled using the preset keys (1 to 6).
¢ Select the desired waveband :
IN A
BAND
"SCAN
« Tune-in the desired station :
<>
=>
* To store the station on the selected preset
number:
yy fy
Pe
)..P CSE
When storing an FM station, the relevant RDS
information and AF mode (on/off) are also
stored on the preset.