Dust Extraction; Inserting And Removing The Battery Pack - Westfalia AZKGS 18 Originalanleitung

store batteries in a high charge state disconnected from the power
tool.
 The capacity of batteries will reduce over time. After 100 charge
cycles, the battery's operation time and the maximum torque per-
formance of the tool will slightly reduce. This decline will continue
until the battery has minimal capacity after 500 charge cycles. This
is normal and not a fault with the battery pack.
Assembly
Insert the workpiece supports (6) into the holes on either side of the
mitre saw. Tighten the workpiece support lock screws (13) to lock the
work supports in position. Check that the supports are firmly held.
The mitre saw is delivered without a saw blade, install a suitable saw
blade with a diameter of 216 mm, a thickness of 1.5 mm and a
mounting hole of 30 mm as described below in the chapter "Replacing
the Saw Blade".
Operation
The mitre saw must be secured to a workbench or saw table. Check all
covers and safety devices have been properly fitted and are operation-
al.
Check the saw head is not locked and is free to move. If not free,
disengage sliding locking screw (24) and head down locking pin (22).
Before inserting the battery (18) check that the saw blade (5) is free to
rotate.

Dust Extraction

The saw dust collection bag or suitable saw dust extraction system
must be connected to the saw dust extraction port (16)

Inserting and removing the Battery Pack

Warning: Before inserting or removing the battery pack, make sure the
mitre saw is switched off.
Please note that the saw will only work correctly with the 4.0 Ah
Battery.
Slide the battery pack into battery slot at the rear of the saw head. To
insert the battery pack, align the battery pack with the battery base at
Operation
25