Husqvarna 1-10DS Bedienungsanweisung Seite 20

6. Engage the drive system. Refer to
product to a power source on page 19 .
7. Start the control panel.
8. Push the ON button (A) to start the blastmotor.
9. Wait until the ammeter is in idle position.
10. Turn the speed control dial to set the drive speed.
To operate the product
WARNING:
rearward operation only. Do not move the
product forward during operation.
WARNING:
during operation. Abrasive comes out of the
product at high speed and can cause injury.
1. Make sure that the work area is safe. Refer to
area safety on page 9 .
2. Fill the abrasive separator with abrasive. Fill the
separator with abrasive when necessary. Refer to
fill the product with abrasive 1-10DS on page 17 or
To fill the product with abrasive 1-15DS on page 18 .
3. Start the product. Refer to
page 19 .
4. Engage the drive system. Refer to
drive system on page 13 .
20
To connect the
A
B
This product is for
Do not lift the blasthousing
Work
To start the product on
To engage the
5. Operate the drive system lever.
6. Pull the abrasive control lever to open the abrasive
valve. Refer to
page 15 .
7. After 2 m, close the abrasive valve and stop the
product.
8. Do a check of the blast pattern. Adjust the blast
pattern if necessary. Refer to
pattern on page 21 .
9. Select the correct speed. Refer to
correct speed on page 19 .
10. Move the product (A) in parallel tracks. The dust
extractor (B) must be connected to the product (A)
by the dust extractor hose (C).
C
B
To
To operate the abrasive valve on
To adjust the blast
To select the
A
2070 - 004 - 06.04.2023