Requirements For Initial Startup Of The Ineos With The Inlab Pc System; Required Accessories - Sirona INEOS Inbetriebnahme

1 Requirements for initial startup of the inEos with the inLab PC system

Required accessories

From the scope of supply of the inLab
system PC:
From the scope of supply of the inEos unit:
Also required:
From hardware version BA:
4
Startup and Installation Instructions for the inLab PC system inEos
1
Requirements for initial startup of the
inEos with the inLab PC system
1.1 Required accessories
● inLab system PC with power cable,
● Keyboard
● Mouse
● From hardware version BA:
2x DVI–VGA converters
● inEos
● inEos power supply unit
● Power cable
● FireWire cable
● RS 232 interface cable
● USB – RS 232 converter with USB cable
● VGA/DVI monitor including VGA/DVI cable (not included in scope of
supply)
CAUTION
Image may not display
Please note the required minimum monitor resolution of 1280 x 1024 at
70Hz. Please refer to the technical documentation of the monitor for the
correct resolution and frame rate settings.
Recommendation:
● Sirona inLab system PC monitor, Order No.: 60 42 548 D3446
In order to connect a VGA monitor, screw one of the two converters onto the
left DVI port as shown in the photo.
Sirona Dental Systems GmbH
60 35 302 D 3446
D 3446.031.01.05.02 06.2009