TROUBLESHOOTING
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
Always disconnect the machine from the power supply before maintenance or
repair work and secure it against unintentional reconnection.
Many possible sources of error can be excluded in advance if the machine is properly connected to
the mains. If you are unable to carry out necessary repairs properly and/or do not have the required
training, always consult a specialist to correct the problem.
Problem
Machine does not start or shuts
down automatically during idling
Machine stops during operation
Machine vibrates during
operation
Workpiece clamps during
thicknessing
Bad surface condition after
operating
Rough surface after operating
Cracked surface after operating
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
W A R N I N G
Possible cause
Power supply outage
Damaged or incorrect
connected extension cable
Damaged switch or motor
Blunt blade
Feeding speed to high
Motor protection triggered
Wrong adjusted blade
Ground not flat or base feet
wrong adjusted
Cutting depth to high
Dirty thicknessing table
Blunt blade
Uneven feed of the workpiece
Workpiece too moist
Workpiece was processed
against the direction of growth
Cutting depth to high
TROUBLESHOOTING
Solution
Check fuse of the power
supply
Check plug or extension
cable
Contact customer support
Check blade
Work with lower feeding
speed
Let the motor cool down
Check the setting of the
blades
Set the base feet correct
Set the correct cutting
depth and operate in more
steps
Clean and apply the table
surface with lubricant
Check blade
Feed workpiece evenly and
with constant pressure
Use drier workpiece
Proceed the workpiece in
opposite direction
Set the correct cutting
depth and operate in more
steps
HOB260ECO
49