Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning, Maintenance, Storage, Disposal; Cleaning; Maintenance; Maintenanceplan - HOLZMANN-MASCHINEN HOB260ECO Betriebsanleitung

Vorschau ausblenden Andere Handbücher für HOB260ECO:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

CLEANING, MAINTENANCE, STORAGE, DISPOSAL

Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
 Always disconnect the machine from the power supply before maintenance or
repair work and secure it against unintentional reconnection.
18.1

Cleaning

Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe
operation.
Incorrect cleaning products can attack the finish of the machine. Do not use any
solvents, nitro thinners or other cleaning products that could damage the machine's
finish.
Observe the specifications and instructions of the cleaning agent manufacturer.
Remove chips and dirt particles from the machine after each use with a proper tool.
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil
(e.g. WD40 rust inhibitor).
18.2

Maintenance

The machine is low maintenance and only a few parts require mainencance. Malfunctions or
defects that are likely to impair your safety must be rectified immediately!
Check that the safety devices are in good condition before each operation.
Check the connections at least once a week for a tight fit.
Check the correct and readable status of the Machine's warning and safety labels on a
regular basis.
18.2.1

Maintenanceplan

Wear of machine depends strongly on operation condition. The following intervals are valid when
using the machine within the operation limits
Interval
Componente
Anti-kick-back
Before every
device
usage
Machine
V-Belt
monthly
Feed/Pull-out roller
Height adjustment
Chain-drive (feed)
Half yearly
Friction wheel
(feed)
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
W A R N I N G
N O T E
Activity
At least once per work-shift by inspection to verify that
they are in good working condition, eg have no impact
damages to the surface and that the anti-kick back device
fall back freely due to its own weight after lifting.
Cleaning (from dust and chips)
Check retighten or replace if necessary.
Check and clean thoroughly
Control, lubrication
Check for damage/wear, lubricate, replace if necessary
Check for damage/wear and replace if necessary.
46
HOB260ECO

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis