Herunterladen Inhalt Inhalt Diese Seite drucken

18.8 Replacing/Adjusting The Planing Knife; Storage; 18.10 Disposal - HOLZMANN-MASCHINEN HOB260ECO Betriebsanleitung

Vorschau ausblenden Andere Handbücher für HOB260ECO:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

18.8 Replacing/adjusting the planing knife

The planer shaft is suitable for strip knives.
If the planing surface is bad, the planing knives must be replaced. The appropriate
dimensions can be found in the technical data.
Danger from cutting edges! Always wear protective gloves when working on the
planing shaft! Injuries to hands due to sharp cutting edges
18.9

Storage

Store the machine in a dry, frost-proof and lockable place when not in use. Make sure that
unauthorised persons and especially children do not have access to the machine.
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil (e.g.
WD40 rust inhibitor).
Improper storage can damage and destroy important components. Only store packed
or already unpacked parts under the intended ambient conditions!

18.10 Disposal

Observe the national waste disposal regulations. Never dispose of the
machine, machine components or operating equipment in the residual waste.
If necessary, contact your local authorities for information regarding available
disposal options.
If you purchase a new machine or equivalent equipment from your specialist
dealer, he is obliged in certain countries to dispose of your old machine
properly.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
N O T E
W A R N I N G
1.
Adjust the machine to thickness planing mode
2. The dust collection hood must be open in order to have access to
the shaft
3. Loosen the gib screws (1)
4. The planing kife (3) will be pushed up by the pressure springs (5)
5. Remove the gib (2) and the planing knife (3)
6. Clean the planer shaft (4) and gibs (2)
7. Replace sharpend/new planning knife (3) and gib (2)
8. Slightly tighten the gib screws (1) and and perform the
adjustment procedure.
9. Place the setting gauge (6) on the planning shaft and adjust the
correct height.
10. Tighten the gib screws (1) to fix the gib (2) (recommended
minimium tightening torque 20Nm)
11. Do not use planning knives with a height of less than 19mm due
to the too small clamping surface
12. Repeat procedure for all planing knives.
N O T E
48
HOB260ECO

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis