Bartscher 900-Serie Bedienungsanleitung Seite 78

All hotplate thermocouple
To substitute the thermocouple of the all hotplate, remove the knobs and take off the control panel.
It is then necessary to unscrew the fitting of the thermocouple on the cock and the one on the pilot
unit, then substitute the part.
Oven thermocouple
To substitute the thermocouple of the oven, it is necessary to remove the knobs and the oven control
panel. Then, unscrew the fitting of the thermocouple on the cock and the one on the pilot unit, then
substitute the part.
Valve of the maxi oven
For replacing the maxi oven , the knob and the side panel of the oven must be removed, then it is
necessary to unscrew the tube which goes to the burner, the tube of the pilot burner, the
thermocouple and at last the gas tubes. Then replace the part.
Oven thermocouple
For substituting the maxi oven thermocouple, the knob and the side panel of the oven must be
removed. It is necessary to unscrew the connection of the thermocouple on the valve, the one on the
pilot and then, replace the part.
Replacing of the heating element of the glass ceramic electric cooker
In order to replace the heating element, unscrew the control panel, unloose the fixing screws of the
frame and take it off, unloose the connection wires of the heating element paying attention to hold
upside the open part of the heating element during the replacing.
Power regulator of the glass ceramic plate.
In order to replace the power regulator of the glass ceramic plate, unscrew the fixing screws of the
instrument panel, remove it, than unplug the electric wires and replace the component. Once
replaced it, plug the wires again referring to the electrical scheme.
Electric components of the electric oven
For the replacement of the selector and of the thermostat of the electric oven, it is necessary to
unscrew the fixing screws of the control board, remove it, then disconnect the electric cables of the
component and replace it. After the replacement, connect the electric cables following the
instructions of the wiring diagram.
Electric oven elements
To substitute the elements of the oven, it is necessary to take out the grill in wire grill, the bottom,
the top diffusor and the grill holders. Then unscrew the fixing screws of the element to be
substituted, remove it from the support from the other side and remove it including the wiring, then
disconnect it.
Pag. 76/100