Electrical Installation - SICK CQF16 Betriebsanleitung

OPERATING INSTRUCTIONS
en
5

Electrical installation

20 O P E R A T I N G I N S T R U C T I O N S | CQF16
Installation possibilities
Table 1: Installation options
Figure 4: Velcro installation
position on a tank
Figure 7: Adhesive mounting
Figure 9: Flush mounting, fig.
1
The sensors must be connected in a voltage-free state (U
tion must be observed, depending on the connection type:
– Male connector connection: Note pin assignment
– Cable: Wire color
Only apply voltage/switch on the voltage supply (U
tions have been established.
Explanations on connection diagram:
NC = normally closed
NO = normally open
Figure 5: Bracket on thin
pipe
Figure 8: Adhesive mounting
Figure 10: Flush mounting,
fig. 2
V
> 0 V) once all electrical connec‐
V
Figure 6: Mounting with
cable ties on a pipe
Figure 11: Flush mounting,
fig. 3
= 0 V). The following informa‐
8022710.1EAN/2022-05-31 | SICK
Subject to change without notice