Led Status Indications; Operating Modes - Abicor Binzel ABIBUG 300 Originalbetriebsanleitung

ABIBUG 300

7.2.2 LED status indications

Indicator
Green LED
Orange LED
Red LED
Blue LED
Magenta LED

7.3 Operating modes

► Observe the information in the software instructions.
The device can be operated with the following two types:
Mode 1
Mode 2
Function
Stand-by mode/standard mode
The device is switched on and ready for
operation.
Work mode
The device is in operation and carrying
out one or more predefined workflows from
programs 1 to 12.
Error mode
The status monitoring has detected an error or the
remote control is not connected. The device is
not carrying out any movements and is stationary.
 10 Faults and troubleshooting on
page EN-62
Programming mode
The device is in service mode or programming
mode. To switch back to stand-by mode/standard
mode, release the <SAVE> button.
Sensor mode
Appears when the <STOP> button is pressed and
held down for 2 seconds. Extinguished after
the <STOP> button is released.
Use of programmed parameter data in programs 1–11
Use of program 12 is only possible if the manufacturer's position sensor
has been enabled. By means of the position sensor, the device
determines when the programmed parameters are automatically
switched/advanced.
7 Operation
EN - 41