Possible Dangers Caused By The Metal Band Saw - Optimum OPTisaw S285DG Betriebsanleitung

We will not be held liable for any damages resulting from any operation which is not in
accordance with the intended use.
We expressly point out that the guarantee or CE conformity will expire due to any constructive
technical or procedural changes which had not been performed by the company Optimum
Maschinen Germany GmbH.
It is also part of intended use that
observe the limits of the metal band saw,

obey the operating instructions,

the inspection and maintenance instructions are observed.


Technical specification on page 74
The decisive factor for achieving efficient cutting and the necessary angular tolerance is the
correct choice of parameters such as the saw belt, feed, cutting pressure, cutting speed and
cooling agent.
WARNING!
Extremely severe injuries.
It is forbidden to make any modifications or alternations to the operation values of the
metal band saw! They could endanger people and cause damage to the metal band saw.
1.4

Possible dangers caused by the metal band saw.

The construction and design of the metal band saw are state-of-the-art.
Nevertheless, there is a residual risk as the metal band saw operates with
electrical voltage and currents and

hydraulic,

an revolting metal band saw blade.

We have used design and safety engineering to minimize the health risk to personnel resulting
from these hazards.
If the metal band saw is used and maintained by personnel who are not duly qualified, there
may be a risk resulting from incorrect or unsuitable maintenance of the metal band saw.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must
be duly qualified,

and strictly follow these operating instructions.

In the event of improper use
there may be a risk to personnel,

the metal band saw and further property might be endangered,

the correct function of the metal band saw may be affected.

Always disconnect the metal band saw from the electrical power supply when performing
cleaning or maintenance works.
WARNING!
The metal band saw may only be used with the safety devices activated. Disconnect the
metal band saw immediately whenever you detect a failure in the safety devices or when
they are not mounted!
All additional devices installed by the operator have to be equipped with the prescribed
safety devices.
This is your responsibility as the operator!

Safety devices on page 68
EN
S285 DG
66 Translation of original instructions
Safety
Version 1.1.2 - 2022-02-24