Maintenance; Safety Recommendations; Routine Maintenance - Stiga MJ 66 Gebrauchsanweisung

both directions. Fig. 5.17)
9. I f the collector system tends to get blocked
with grass, you should reduce the forward
speed as it may be too high for the condition of
the grass. If the problem persists, the probable
causes are either badly sharpened cutting
means or deformed fins.
10. B e very careful when mowing near bushes
or kerbs as these could distort the horizon-
tal position of the cutting-means assembly
and damage its edge as well as the cutting
means.

6. MAINTENANCE

6.1 SAFETY RECOMMENDATIONS

WARNING! You must go to a specialized
Operation
1. MACHINE
Cutting means positioning and sharpening
1.1
check
3)
1.2
Replacing cutting means
1.3
Transmission belt check
1.4
Transmission belt replacement
1.5
Cutting means control belt check
Replacing the cutting means control belt
1.6
check
2) 3)
1.7
Brake regulation and check
1.8
Drive regulation and check
1.9
Cutting means engage and brake check
1.10
Complete bolt and screw check
1.11
General lubrication
2. ENGINE
1)
2.1
Replacement of the engine oil
2.2
Air filter cleaning and check
2.3
Air filter replacement
2.4
Fuel filter check
2.5
Fuel filter replacement
2.6
Spark plug points cleaning and check
2.7
Replace spark plug
3)
3)
2) 3)
3)
3)
3)
3)
4)
Service Centre or contact your Dealer if the
following are malfunctioning:
– the brake;
– the cutting means engage and disengage
functions,
– switching the drive to forward or reverse
gears.

6.2 ROUTINE MAINTENANCE

The table will help you maintain your machine's
safety and performance. It summarises the main
interventions to be made and the frequency ap-
plicable to each of them.
The boxes at the side are for you to mark the date
or number of working hours at which the interven-
tion was made.
Hours Completed (Date or Hours)
25
100
25
–
25
–
25
25
25
25
25
...
...
...
...
...
...
...
EN - 14