Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.7.8
Display overview
Laser beam is out of
aim
Current point number
Laser beam position
indicator
Saved measurements
for the current
measurement point
Saved result for the Y-
Axis
Saved result for the X-
Axis
Number of the
measurements current
measurement point
To carry out (and save) a measurement or to replace a measurement, press
and
, to switch between the measurement points (positions). Always pay attention to the current
selected side of the shaft and switch it (if recommended) by pressing
7.7.9
View and save results
If the measurements for all measurement points are finished, press
reference line models you can chose between by pressing
Ref.point Mode: if one of the reference points is undefined, the result is the unchanged receiver value. If
two reference points are defined, the result is the difference between the calculated reference line and the
receiver value.
To define reference points, press
Press
to confirm. In order to delete a reference point, enter
Best- Fit Mode: in this mode, the result is the difference between the calculated best fit reference line and
the receiver value.
The result can be displayed as a table or a graph. Due to
Manual
No connection to the
Not ready (wait)
Switch to the opposite side
(12 and 6 o'clock)
and enter reference point number 1 and reference point number 2.
54
Receiver values „-
,--„ means that
sensors
data are not ready
Inclination indication:
Blue area shows the
allowed position
Inclination value
should be entered
manually for every
Inclination indication of
the saved
measurements
Y-, X- and inclination
value of the saved
measurement
. Use
.
,to display a result. There are two
.
as the value.
, you can switch between these illustrations.
side
Werbung
Inhaltsverzeichnis
