Data Acquisition - PCE Instruments PCE-TU 3 Bedienungsanleitung

7.2.3

Data acquisition

To collect data, press
What should be noted in this window
Before starting a new alignment
process, you need to enter dimensions
and parameters
Do not change the position of
measurement units when work is
interrupted
Laser is now switched on
Functions in this window
- Collect measured values (up to 36)
- Select between auto sweep and
manual mode
- Manual entry of Ys- and Ym-values (if
activated)
- Manual angle/inclination entry (if
activated)
- Selection of measurement unit
(mm/inch)
- Navigate through collected data
- Delete/add/replace measured values
- Restart (all values are deleted)
- Set Offset
Manual
.
Shortcuts in this window
Start again (deletes all values)
Confirmation dialogue appears
Enter Ys-values, if manual entry is activated
Enter Ym-values, if manual entry is
activated
Enter angle/inclination, if manual entry is
activated
If cursor is on the first place in the entry
field, push this button twice to reverse sign
Select the measurement unit (mm or inch)
Set parallel misalignment (Offset)
Save all data in one file (see chapter 10
„Handling of the Data Dialogue window")
Load data from file (see chapter 10
„Handling of the Data Dialogue window")
Delete currently selected reading
Enter new value. You have to switch to the
last value saved, to make this option
31
The built-in inclinometer
cannot be used within the
vertical alignment mode