Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8.3.10 Carry out, access and replace measurement
To carry out a measurement, press
Point number
Saved
measurement value
(here it is empty)
To navigate through the saved values, use
and conform by pressing „Yes" in the following dialogue window.
press
8.3.11 View and save results
If the measurements for all planes are finished, press
models, you can switch between pressing
Ref.point Mode: if one of the reference points is undefined, the result is the unchanged receiver value. If
two reference points are defined, the result is the difference between the calculated reference line and the
receiver value.
To define reference points, press
Press
to confirm. In order to delete a reference point, enter
Best- Fit Mode: in this mode, the result is the difference between the calculated best fit reference line and
the receiver value.
The result can be displayed as a table or a graph. Due to
To save the result, press
To return to the main menu of the program, press
Manual
. Saved values are displayed as a result.
Number of the overlap point
Visible, if the current point is an
overlap point of the splice
and
.
and enter reference point number 1 and reference point number 2.
, (refer to chapter 10„Handling of the Data Dialogue window")
78
Splice (if used)
Receiver Y-axis
value
Receiver X-axis
value
Number of the saved
measurement values (here it
is „0"). Changes to „1", as
soon as a value is saved.
. To replace the selected measurement value,
, to view the result. There are two reference line
as the value.
, you can switch between these illustrations.
Werbung
Inhaltsverzeichnis
