Operation; Tilting Motor Up/Down And Shallow Water Position - Torqeedo Cruise 3.0 R Originalbetriebsanleitung

DE EN
» Set the accelerator lever/tiller to the neutral position.
NOTE! Pressing the emergency skill switch or pulling the kill switch cord switches
the system off. To put it back into operation, it must be restarted.
NOTE! Do not use the emergency kill switch or pull the kill switch line cord switch
off the system regularly if there is no emergency situation.
• Press the emergency kill switch or pull the kill switch cord.
» To continue travelling, reset the emergency kill switch or reinsert the kill
switch cord.
» Set the accelerator lever/tiller to the neutral position.
» Start the Torqeedo system.
• Set the battery main switch to the "OFF" position to switch off the system.
» To continue the journey, put the accelerator lever/tiller into the neutral
position.
»
Reset the emergency kill switch or insert the kill switch cord (if present).
» Set the battery main switch to the ON position.
» Start the Torqeedo system.
» Insert the emergency stop magnetic chip (if present).

8.2 Operation

8.2.1 Tilting motor up/down and shallow water position

You can tilt the motor up or down to several positions for sailing in shallow
waters, or to take the motor out of the water when not in use.
Danger of crushing due to uncontrolled tilting of the transom bracket. This
can result in minor or moderate bodily injuries.
• Do not grasp the tipping area of the motor during tipping.
74
CAUTION
Danger of accident due to reduced braking effect caused by the motor tilting
upwards. This can result in minor or moderate bodily injuries.
• After using a shallow water position or the highest bearing position,
always set the Lock / Tilt lever to the "Lock" position and ensure that the
motor cannot tip up.
NOTE! Material damage due to overheated components. The motor of the Torqee-
do system is only intended for operation in water. Prolonged spinning of the
propeller on land or in dry conditions will result in component damage. Always
use a shallow water position with the propeller below the water surface.
Tilting up the motor
Lock Auto kick-up
1
1. Set the tilt lever (1) to the "Tilt / Auto kick-up" position.
2. Tilt the motor upwards by pulling the tilt lever (2) and then tilt the motor to
the desired position.
CAUTION
2
Tilt/