Setting Forwards/Reverse Motion; Operation; Operation In Emergency Situations - Torqeedo Cruise 3.0 R Originalbetriebsanleitung

5. Restart the system.
» The motor and batteries now communicate directly with each other. You
can, among other things, read the state of charge of the batteries on the
display.
NOTE! When using the Cruise system with a different battery bank, the enumera-
tion must be carried out again.
NOTE! Torqeedo Power 48-5000 will be displayed as 2 batteries.

7.1.3 Setting forwards/reverse motion

You can adjust the direction of tiller/accelerator lever rotation for forwards/re-
verse motion according to your needs.
NOTE! Depending on the configuration and the accelerator lever used, the
settings menus differ for the Cruise models without tiller. The corresponding
information can be found in the operating manual for the respective accelerator
lever.
Setting forwards/reverse motion (only Cruise models with tiller)
1
setup cal.
1. Press the CAL button (1) for 10 seconds.
» "cal up" is displayed.
2. Turn the tiller forward to full throttle in the desired direction of rotation.
3. Press the CAL button.
» "cal stp" is displayed.
4. Turn the tiller to the neutral position (N).
5. Press the CAL button.
» "cal dn" is displayed.
6. Turn the tiller backward to full throttle in the desired direction of rotation.
7. Press the CAL button.
» Setting forwards/reverse motion is completed.

8 Operation

WARNING
Danger to life due to boat not being manoeuvrable! This can result in moder-
ate or severe bodily injuries.
• Find out about the intended travel area before you set off and observe
the forecast weather and sea conditions.
• Depending on the size of the boat, always have the necessary safety
equipment ready (anchor, paddle, means of communication, auxiliary
drive if necessary).
• Check the system for mechanical damage before starting to drive.
• Only drive with a system that is in perfect working order.

8.1 Operation in emergency situations

You can stop your Torqeedo motor in several ways in an emergency. The system
has appropriate safety features for this purpose. Depending on the configuration,
the system has either an emergency stop magnetic chip or a kill switch cord with
switch or an emergency kill switch.
Please note that the type of stop impacts the restart.
• Set the remote throttle/tiller to the neutral position to stop the motor.
» To continue travelling, you can simply give forwards/reverse motion again.
• Pull off the emergency stop magnetic chip to stop the motor.
» To continue travelling, replace the emergency stop magnetic chip.
DE EN
73