Assembling The Cultivator - Stihl MH 700 Gebrauchsanleitung

English
► Fill the oil bath air filter,
► Refuel the tiller,
► Adjust the handlebar for the user,
► Check the controls,
► If the steps cannot be performed: do not use
the tiller and consult a STIHL specialist dealer.
6

Assembling the Cultivator

6.1 Fitting and Removing the
Blades
6.1.1 Attaching the Hoes
► Stop the engine.
► Fit covers (1) and couplers (2) on drive
shaft (3).
► Tighten locking screws (4).
► Assemble hoe halves (5 and 6) so the bores
align.
► Insert bolt (7) into the bores.
► Place washers (8) and spring washer (9) on
bolt (7).
► Screw on nut (10) and tighten firmly.
► Push hoes (11) onto drive shaft (3) so the
bores align.
► Push folding retainers (12) through the bores
in drive shaft (3) and close the securing clips.
Hoes (11) are secured.
6.1.2 Removing the Hoes
► Stop the engine.
► Pull out the folding retainers.
36
6.11
7.1
8
10.1
► Remove the hoes.
► Push the folding retainers through the bores in
the drive shaft.
The folding retainers are kept in place.
6.2 Attaching and Removing the
Running Wheels
6.2.1 Attaching the Running Wheels
► Stop the engine.
► Loosen bolts (1) on running wheel (2).
► Remove washers (3), spring washers (4) and
nuts (5).
► Place axle mount (6) on running wheel (2) so
the bores align.
► Insert bolts (1).
► Place washers (3) and spring washers (4) on
bolts (1).
► Screw on nuts (5) and tighten firmly.
Axle mount (6) must not be dismantled again.
► Push running wheels (7) onto drive shaft (8)
so the bores align.
► Push folding retainers (9) through the bores in
drive shaft (8) and close the securing clips.
Running wheels (7) are secured.
6.2.2 Removing the Running Wheels
► Stop the engine.
► Pull out the folding retainers.
► Remove the running wheels.
6 Assembling the Cultivator
0478-404-9804-B