Displaying State Of Charge; Led On Charger; Assembling The Garden Pruner; Mounting The Bar And Chain - Stihl GTA 26 Gebrauchsanleitung

English
plug is plugged into a socket
and the battery is inserted into
the charger. The charger
switches off automatically when
the battery is fully charged.
The battery and the charger warm up during
charging.
1
3
► Insert the mains plug (5) in a convenient wall
outlet (6).
The charger (2) runs a self test. The LED (3)
glows green for about 1 second and then red
for about 1 second.
► Fit the connecting cable (4).
► Insert the battery (1) in the guides in the
charger (2) and press it home as far as stop.
The LED (3) glows or flashes green. The bat‐
tery (2) is being charged.
► When the LED (3) stops glowing: The battery
(1) is fully charged and can be taken out of the
charger (2).
► If the charger (2) is no longer required. Dis‐
connect the mains plug (5) from the wall outlet
(6).
6.3

Displaying State of Charge

1
► Insert battery.
► Press the button (1).
The LEDs emit green light for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
38
2
6
5
4
80-100%
60-80%
40-60%
20-40%
0-20%

7 Assembling the Garden Pruner

6.4 LEDs on Garden Pruner
The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
18.
There is a malfunction in the garden pruner or
battery.
6.5

LED on Charger

The LED indicates the operating status of the
charger or faults. The LED can glow or flash
green or red.
If the LED glows or flashes green, the battery is
being charged.
► If the LED glows or flashes red: Troubleshoot‐
ing, 18.
There is a malfunction in charger or battery.
7 Assembling the Garden
Pruner
7.1 Removing and Fitting the Bar
and Chain
7.1.1 Removing the bar and chain
► Switch off the garden pruner and remove the
battery.
2
1
3
► Raise the grip (1) of the wingnut (2).
► Rotate the wingnut (2) counterclockwise until
the chain sprocket cover (3) can be removed.
► Remove the chain sprocket cover (3).
► Remove the bar and chain.
7.1.2

Mounting the bar and chain

The bar and chain combinations that can be
used with the chain sprocket are listed in the
specifications, 20.1.
0458-694-9621-B