Installation Into The Radio Slot - Renkforce dvd 6311 Bedienungsanleitung

Installation into the radio slot

• Remove the front control panel.
1
1
2
• Remove the two safety screws from the DVD drive (illustration 1, no. 1).
• Unlock the installation frame using the two unlocking keys (illustration 1, no. 2).
• Remove the installation frame towards the back of the system (illustration 1, no. 3).
• Insert the frame into the radio slot (illustration 2).
• Bend down some clips of the installation frame until the frame is securely fastened in the slot (illustration 3).
• When you have set up all the electrical connections (see "Electrical connection"), insert the device into the
installation frame until it snaps in (illustration 4).

Keep the two unlocking keys. You will need them for future removal of the device.
Protect the device against vibrations using the bolt at the back of the unit.
Most vehicles are already equipped with such a safety fastening. If this is not the case in your car, fasten the device
using a punched metal strip or similar.
2
3
182mm
3
53mm
4
57