Assembling The Synchronisation Shaft (With Protective Tube) - RK Rose+Krieger RK MonoLine R Montageanleitung

5.4.2.2

Assembling the synchronisation shaft (with protective tube)

Applicable to
Assembling the intermediate plate
Fig. 25: Assembling the intermediate
plate
14.10.2021
Assembling optional modules > Assembling the synchronisation shaft
Size
40
60, 80
120
ð The synchronisation shaft is assembled.
Version
Size
Personnel:
Protective equipment:
Prerequisites:
n The electric gear unit and/or motor (if available) are secured
against restarting.
Linear units to be connected must be fixed in the substrate.
n
The synchronisation shaft for the RK MonoLine Z
60 and Z 80 does not require the first step because
it is not equipped with an intermediate plate.
1. Place the intermediate plate (Fig. 25/1) on the pulley box
(Fig. 25/2) of both linear units.
2. Tighten 4 screws each (Fig. 25/3), alternating diagonally:
Size
40
120
Linear unit RK MonoLine R/RK MonoLine Z
Screw size
M3
M6
M8
RK MonoLine Z
40/60/80/120
n Assembly staff
n Protective clothing
n Protective gloves
n Safety shoes
Screw size
M5
M8
Assembly
Tightening torque [Nm]
1.4
10.5
25
Tightening torque [Nm]
4
25
103