Repair Service - EKOM DK50 2x4VR/110 Benutzerhandbuch

Once a dryer fault is cleared and after its reassembly, the dryer should quickly be regenerated, best
when using continuous compressor operation at a pressure of around 1 bar for a period of at least
1 hour; then check the dryness of the compressed air.
Check the moisture content of the air exiting the air tank (see the Technical data
chapter) to prevent damage to connected downstream equipment.

21. REPAIR SERVICE

Warranty and post-warranty repairs must be done by the manufacturer, its authorized
representative, or service personnel approved by the supplier.
Attention.
The manufacturer reserves the right to make changes to the equipment without notice. Any changes
made will not affect the functional properties of the equipment.
NP-DK50 2x4VR 110-AD-A-1_09-2020 56
TROUBLESHOOTING
09/2020