EKOM DK50 2x4VR/110 Benutzerhandbuch Seite 29

INSTALLATION

Open the web browser on a PC,
smartphone or tablet and enter the IP
address of the controller (in this case
192.168.0.3).

Enter the password "LOGO" and click
on the "LOG on" button.

After logging in, the browser displays
the first screen showing the system
information for the controller itself:
module generation,
(FW), IP address and activity status.

Click on the "LOGO! BM" function in the
browser to display the current virtual
status of the display screen. Navigate
through the screen using the ESC and
cursor keys the same as on the real
display.
Monitoring memory variables
The "LOGO! Variable" function is the other option for monitoring compressor parameters using
selected memory variables. Click the "LOGO! Variable" button on the display to bring up a screen
and then use the "Add Variable" button to select specific memory variables for monitoring based on
the mapping provided by the compressor manufacturer.
Variables assigned based on addresses and models may be viewed in the MAPPING
PARAMETERS table (see the Annex chapter).
Select the variable parameters (per the annex) sequentially in the Range, Address, Type and
Display Format columns. Variable values are shown in the Value column. The monitoring table may
then appear as follows
09/2020
type, firmware
29 NP-DK50 2x4VR 110-AD-A-1_09-2020