urmet 1092/602 Bedienungsanleitung Seite 77

10.5.8.2 Program vectorscan – definition of a path made by preset, pattern and vectorscan
Select PROGRAM VECTORSCAN and press OPEN to access the following submenu:
Opzione
Number
Program a VectorScan
Run a VectorScan
Delete a VectorScan
PROGRAM A VECTORSCAN
Select Program a VectorScan and press OPEN to access the following submenu where it is possible to
define the parameters of the VectorScan to be stored:
PROGRAM VECTORSCAN
Name
1 -
2 -
3 Pr
4 -
5 -
6 -
7 -
8 -
IRIS CLOSE When Done
Use the arrow buttons to move the cursor in the position where the data must be entered.
1 – is the action number; up to 16 actions max. can be entered.
Name – is the action kind; with the button OPEN select Pr (Preset), Vs (VectorScan),Pt (Pattern).
Num – is the number referred to the previous storage value of the selected action; press the button OPEN to
access the selection screen.
1~50 64~77 102~165
_ _ _ ∟
0123456789
Press the arrow buttons to move the cursor in the desired position.
Press the button OPEN to access the numeric selection.
Press the arrow buttons to select the desired number.
Press the button OPEN to confirm it.
Press the button CLOSE at the end of selection.
Move on the symbol ∟ and press the button OPEN to go back to the previous screen.
SP – is the movement speed between two actions; values from 1 to 9 can be selected, press the button
OPEN to select the desired speed.
DS1092-090
Valore
1 ÷ 6
/
/
/
Num SP Dwell
- - -
- - -
1 5 3
- - -
- - -
- - -
- - -
- - -
Spiegazione
This option allows to identify VectorScan to be stored.
Up to 6 VectorScan max. can be selected.
This option allows to define the operations to be
performed by the selected VectorScan (16 max.). For
each operation it is possible to define the action
kind, the number to which it is associated, the
movement speed and the dwell time (see below).
This option allows to start the selected VectorScan.
This option allows to delete the selected VectorScan by
pressing twice the button OPEN.
77