Important Safety Notes; Accessories - urmet 1092/602 Bedienungsanleitung

8

IMPORTANT SAFETY NOTES

The following important notes must be followed carefully to work the Thera 5 Ref.1092/602 camera and
respective accessories in total safety.
The term "video system" here means a camera and all components needed for its operation (e.g., power,
leads, supports, control board and more).
Read the instructions
Read all safety rules and instructions carefully before starting to work the video system.
Keep the instructions
Keep the safety notes and instructions for use for future reference.
Respect the warnings
Pay attention to all warnings on the camera and in the instruction manual.
Follow the instructions
Follow the instructions in the instruction manual to the letter.
Cleaning
Disconnect all electrical parts from the mains before cleaning.
Attachments
Do not use attachments other than those recommended in the instruction manual because this could cause
risks for the products.
Water and humidity
Do not use any part of the video system near water, i.e. bathtubs, wash basins, sinks, tubs, on damp
surfaces, near swimming pools, etc.

Accessories

Do not position the camera on unsteady trolleys, stands, brackets or tables. The camera could fall and
severely injury adults and children in addition to seriously damaging the product. Follow the instruction
manual and only use the recommended accessories for the camera for installation and set-up.
Ventilation
Never position the camera near or over radiators or sources of heat. Check that the area is suitably
ventilated before installing the camera inside partially closed areas (such as recesses, bookshelves and
shelves). Refer to the instructions shown in the installation manual.
Electrical power
A switch for performing maintenance operations on the camera must be included.
Connect the camera only to the electrical power supply shown on the ratings plate. Contact your retailer if in
doubt.
Power lead protection
Lay the power wires keeping them from being trodden on or squeezed by objects placed on top of them. Pay
particular attention to leads near plugs, screws and the product outlet.
Lightening
Disconnect the power lead and the wiring to protect the camera during electrical storms or when it is left
unattended and not used for a long time. This will prevent damage to the video system in the event of
lightening or electrical line overload.
Overloads
Do not overload the electrical power and the extensions to prevent the risk of fire or electrocution.
Penetration of liquid and objects
Do not insert objects of any kind through the camera openings to avoid touch live parts: fire and electrocution
risk. No not pour any kind of liquid on the device.
DS1092-090 49