struers Exotom-100 Gebrauchsanweisung Seite 233

Rubber curtains mean trouble-free
cutting of very long workpieces.
Move the swivelling control panel for
optimum access
After contact, the wheel is auto-
matically retracted a little from
the workpiece, to be ready for
cutting. QuickPosition can be used
both before and during cutting.
Cutting Long Workpieces
If the user wants to cut
workpieces protruding the
cutting chamber, it is possible to
swivel the control panel aside, for
easy access. The cutting
chamber comes standard with
side-mounted rubber curtains,
for protruding workpieces.
Programmable Return Position
The return position of the cut-off
wheel can be set to three
different positions: Exotom-100
retracts the cut-off wheel to the
top position, to the position
where the cutting was started or
it lets the cut-off wheel stay in
the cut. In this way, it is very easy
to get convenient access to the
workpiece or an extremely quick
exchange when cutting uniform
workpieces.
Electronic Monitoring
More than a dozen electronic sen-
sors monitor the complete cut-
ting process and all machine func-
tions to ensure flawless cutting.
Never has sectioning on a large
cut-off machine been this safe.
Safety Features
Exotom-100 complies with
international safety standards,
and safety features include
emergency stops and safety
sensors for all machine functions
and motors. The cutting motor
cannot be started before the
protection hood is closed, and
after Start, the hood cannot be
opened before the machine has
stopped. The windows of the
protection hood are made of
impact resistant material.
Cut-off wheels
A range of cut-off wheels for all ferrous and non-ferrous metals is
available for Exotom-100.
Diamond cut-off wheels are available for cutting of ceramic and
mineralogical materials and sintered carbides.
Application
For ExciCut and direct cutting of
extremely hard steels (350-800 HV)
For ExciCut and direct cutting of steels
(< 500 HV). Extremely hard (white cast
iron) or ductile (18/8 or St60) steel types
are cut with oscillating cutting.
Gives good wheel economy
For ExciCut and direct cutting of very
hard and ductile ferrous metals.
Strong, fibre-reinforced wheel
(250-700 HV)
For ExciCut and direct cutting of steels
(< 500 HV).
Gives very good wheel economy
For ExciCut and direct cutting of
non-ferrous metals (< 300 HV).
Primarily for ExciCut
For direct cutting of hardened steels
For direct cutting of sintered
carbides and ceramics
Dimensions Abrasive
432 x 3.0 x 32 mm Al O
2 3
432 x 3.0 x 32 mm Al O
2 3
432 x 3.0 x 32 mm Al O
2 3
432 x 3.0 x 32 mm Al O
2 3
432 x 3.0 x 32 mm SiC
406 x 1.8 x 32 mm CBN
350 x 1.8 x 32 mm Diamond
305 x 1.8 x 32 mm Diamond
Code
101MA
102MA
202MA
104MA
106MA
108MA
26EXO
25EXO