struers Exotom-100 Gebrauchsanweisung Seite 23

Setting the Cutting Parameters
Cutting on Exotom-100
Starting the Cutting
Fast advance
Stopping the Cutting
(Manual Stop)
Re-starting cutting
Exotom-100
Instruction Manual
The Cutting Parameters, FEED, FORCE and STOP, are set in the
Cutting Menu.
m If in CONFIGURATION Menu, press MENU m once to
select Cutting Menu.
D
Push knob to toggle between parameters in the Cutting
Menu.
D
Turn knob to edit the value of the selected parameter.
D
Push knob to move to next parameter.
Position the cut-off wheel.
Close the protection hood.
Press START . The cut-off wheel starts rotating, the cooling water
s
starts running and the cut-off wheel will slowly move down into the
workpiece at the pre-set Feed Rate.
After START s has been pressed, the cut-off wheel may also be
advanced towards the workpiece manually. To advance the cut-off
wheel, push the joystick downwards. The cut-off wheel will
advance towards the workpiece at maximum speed (5mm/s).
Exotom-100 automatically stops cutting when the workpiece is cut
through.
Press STOP to manually interrupt the cutting process.
o
The machine can be stopped at any time during operation by
pressing STOP o .
Having interrupted cutting, the cut-off wheel has been
automatically moved out of the workpiece.
Press START
s
to resume cutting.
17