Qualification Of Personnel - Bosch Rexroth PRC7000 MGDM-BASIC Betriebsanleitung

R911407405 | Rexroth PRC7000 MGDM-Basic
Training options
• operation or storage outside the specified environmental conditions
(e.g. air humidity),
• electrical connection does not correspond to documentation.
Bosch Rexroth AG does not assume any liability for damages caused
by inappropriate use. The risks resulting from inappropriate use are
borne by the operator/user alone.
2.4

Qualification of personnel

The present documentation is designed for specifically trained, skilled
personnel with special knowledge of the welding technology.
This group of persons must have profound knowledge of the software
and hardware components of the welding system.
Use of unqualified personnel or non-compliance with warning
notes !
Possibility of reduction of safety of persons/systems, function
disturbances/restrictions!
Make sure that all work is carried out by properly qualified personnel

only.
Make sure that warning notes/instructions on the product or the

related documentation are observed.
Project engineering, programming, start and operation as well as the

modification of program parameters is reserved to properly trained
skilled personnel! This personnel must be able to judge potential hazards
arising from programming, program changes and in general
from the mechanical, electrical, or electronic equipment.
Interventions in the hardware and software of our products, unless

described otherwise in the related documentation, are reserved to
our specialized personnel.
Our written approval is required with respect to other persons!
Only skilled personnel who are familiar with the contents of the relevant

documentation may install, operate and service the products
described.
Such personnel are
• those who, being well trained and experienced in their field and
familiar with the relevant norms, are able to analyze the jobs
being carried out, recognize any hazards which may have arisen
and take suitable safety measures.
• those who have acquired the same amount of expert knowledge
through years of experience that would normally be acquired
through formal technical training.
Please note our comprehensive range of training courses for personnel
qualification!
For the latest information on training courses, teachware and
training systems please refer to
Bosch Rexroth AG
WARNING
49/80