Adjusting The Tracking; Checking The Tire Pressure; Checking The Wheel Lug Nuts - Toro 2000 HDX RD Serie Bedienungsanleitung

Adjusting the Tracking

1. Disengage the blade-control switch (PTO).
2. Drive to an open, flat area and move the
motion-control levers to the N
position.
3. Move the throttle midway between the F
S positions.
LOW
4. Move both motion-control levers forward until
they both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. If the machine tracks to the right, insert a 3/16
inch hex wrench through the access hole in the
right front cover panel and rotate the tracking
screw clockwise or counterclockwise to adjust
the travel of the lever
7. If the machine tracks to the left, insert a 3/16
inch hex wrench through the access hole in the
right front cover panel and rotate the tracking
screw clockwise or counterclockwise to adjust
the travel of the lever
8. Drive the machine and check the full forward
tracking.
9. Repeat the adjustment until the desired tracking
is obtained.
Figure 56
Right control lever shown
1. Access hole on front cover
panel
-
EUTRAL LOCK
and
AST
(Figure 56).
(Figure 56).
g035859
2. Tracking screw

Checking the Tire Pressure

Service Interval: Every 50 hours/Monthly (whichever
comes first)
Maintain the air pressure in the front and rear tires
at 90 kPa (13 psi). Uneven tire pressure can cause
uneven cut. Check the tires when they are cold to get
the most accurate pressure reading.
Checking the Wheel Lug
Nuts
Check and torque the wheel lug nuts to 122 to 136
N∙m (90 to 100 ft-lb).
45
Figure 57
g001055