Bleeding The Hydraulic System; Mower Deck Maintenance; Blade Safety; Servicing The Cutting Blades - Toro 2000 HDX RD Serie Bedienungsanleitung

Bleeding the Hydraulic
System
1. Raise the rear of machine and support it with
jack stands (or equivalent support) just high
enough to allow the drive wheels to turn freely.
Figure 71
1. Jacking points
2. Start the engine, move the throttle control ahead
to the 1/2 throttle position, and disengage the
parking brake.
A. Move the bypass levers into the pushing the
machine position. With the bypass valves
open and the engine running, slowly move
the motion-control levers in both forward
and reverse 5 or 6 times.
B. Move the bypass levers into the operating
the machine position.
C. With the bypass valve closed and the
engine running, slowly move the control
lever in both forward and reverse directions
5 to 6 times.
D. Shut off the engine and check the fluid
level in the expansion reservoir. Add the
specified fluid until it reaches the F
line on the expansion reservoir.
3. Repeat step 2 until all the air is completely
purged from the system.
Note:
When the transaxle operates at normal
noise levels, moves smoothly forward, and
reverses at normal speeds, it is purged.
4. Check the fluid level in the expansion reservoir
a final time. Add the specified fluid as until it
reaches the F
ULL
reservoir.
ULL
C line on the expansion
OLD
Mower Deck
Maintenance

Blade Safety

•
Inspect the blades periodically for wear or damage.
•
Use care when checking the blades. Wrap the
blades or wear gloves, and use caution when
servicing the blades. Only replace or sharpen the
blades; never straighten or weld them.
•
On multi-bladed machines, take care as rotating
one blade can cause other blades to rotate.
•
Replace worn or damaged blades and bolts in sets
to preserve balance.
Servicing the Cutting
Blades
g017625
Before Inspecting or Servicing the
Blades
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and
disconnect the spark-plug wires from the spark
plugs.
Inspecting the Blades
Service Interval: Before each use or daily
1. Inspect the cutting edges
2. If the edges are not sharp or have nicks, remove
and sharpen the blade; refer to
Blades (page
3. Inspect the blades, especially in the curved area.
C
OLD
4. If you notice any cracks, wear, or a slot forming
in this area, immediately install a new blade
(Figure
54
(Figure
55).
72).
72).
Sharpening the